COMPUTER POWER SUPPLY

:''This article is about the common off-line switching power supplies used in desktop IBM PC compatible computers. There are many other kinds of computers with differing power supplies.''
A 'computer power supply unit' (Computer PSU), or 'Modular Power Supply Unit' (MPS) is the component that supplies power to a computer. More specifically, a power supply is typically designed to convert 100-120 V (North America and Japan) or 220-240 V (Europe, Asia and Australia) AC power from the mains to usable low-voltage DC power for the internal components of the computer. Some power supplies have a switch to change between 230V and 115V. Other models have automatic sensors that switch input voltage automatically, or are able to accept any voltage between those limits.
The most common computer power supplies are built to conform with the ATX form factor. The most recent specification of the ATX standard is version 2.2, released in 2004. This enables different power supplies to be interchangeable with different components inside the computer. ATX power supplies also are designed to turn on and off using a signal from the motherboard (PS-ON wire), and provide support for modern functions such as the standby mode available in many computers.

Contents

Wattage

Appearance

External

Connectors

Internal

AT vs. ATX

Laptops

Energy efficiency

Small facts to consider

Wiring diagrams

False Advertising

Modular power supply

Troubleshooting

Capacitors

Noisy fan

See also

External links

Computer Power Supply Calculators

Wattage

Computer power supplies are rated for certain wattages based on their maximum output power. Typical rated wattages range from 200 W to 500 W, although units used by gamers and enthusiasts usually range from 500 W to 800 W, with the highest end units going up to 2 kW for extreme performance computers with multiple processors and graphics cards (ATI CrossFire or NVIDIA SLI).

Appearance

External

Most computer power supplies have the appearance of a square metal box, and have a large bundle of wires emerging from one end. A label on one side of the box lists technical information about the power supply, including maximum wattage.

Connectors

Typically, power supplies have the following connectors:

★ 'PC Main' power connector (usually called 'P1'): Is the connector that goes to the motherboard to provide it with power. The connector has 20 or 24 pins. One of the pins belongs to the PS-ON wire mentioned above (it is usually green). This connector is the largest of all the connectors. In older AT power supplies, this connector was split in two: 'P8' and 'P9'. If you have a power supply with 24-pin connector, you can plug it into a motherboard with a 20-pin connector. In cases where the motherboard has a 24-pin connector, some power supplies come with two connectors (one with 20-pin and other with 4-pin) which can be used together to form the 24-pin connector.

★ '4-Pin Peripheral' power connectors (usually called 'Molex' for its manufacturer): These are the other, smaller connectors that go to the various disk drives of the computer. Most of them have four wires: two black, one red, and one yellow. Unlike the standard mains electrical wire color-coding, each ''black wire'' is a ground, the ''orange wire'' is +3.3 V, the ''red wire'' is +5 V, and the ''yellow wire'' is +12 V.

★ '4-Pin Floppy drive' power connectors (usually called 'Mini-connector'): This is one of the smallest connectors that supplies the floppy drive with power. In some cases, it can be used as an auxiliary connector for AGP video cards. Its cable configuration is similar to the Peripheral connector.

★ 'Auxiliary' power connectors: There are several types of auxiliary connectors designed to provide additional power if it is needed.

★ 'Serial ATA' power connectors: a 15-pin connector for components which use SATA power plugs. This connector supplies power at three different voltages: +3.3, +5, and +12 volts.

★ Most modern computer power supplies include 6-pin connectors which are generally used for PCI Express graphics cards, but a newly introduced 8-pin connector should be seen on the latest model power supplies. Each PCI Express 6-pin connector can output a maximum of 75 W.

Internal

Inside the computer power supply is a complex arrangement of electrical components, including diodes, capacitors and transformers. Also, most computer power supplies have metal heat sinks and fans to dissipate the heat produced. The speed of the fan is often dependent on the temperature, or less often the power load. It may be dangerous to open a power supply even if it is not connected to an electrical outlet, as high voltages may still be present in charged capacitors. However, for most PSU's this can be fixed by unplugging the PSU and then pressing the power-on button, which will drain the capacitors. Still, care should be taken as some PSU's require a load on the output in order to discharge the capacitors fully. Even when the PC is turned off, a PSU will draw some power from the wall, most of it going to power the ''5Vsb'' (standby) rail.

AT vs. ATX

There are two basic differences between old AT and newer ATX power supplies:

★ The PC main connectors (see above description of connectors).

★ The soft switch. On older AT power supplies, the Power-on switch wire from the front of the computer is connected directly to the power supply. On newer ATX power supplies, the switch goes to the motherboard, allowing it to control the turning off of the system via a message from the operating system.

Laptops

Most portable computers have power supplies that provide 15 to 100 watts. In portable computers (such as laptops) there is usually an external power brick which converts AC power to one DC voltage (most commonly 19v), and further DC-DC conversion occurs within the laptop to supply the various DC voltages required by the other components of the portable computer.

Energy efficiency

Computer power supplies are generally about 70–75% efficient^[1]; to produce 75W of DC output they require 100W of AC input and dissipate the remaining 25W in heat. Higher-quality power supplies can be over 80% efficient; higher energy efficiency uses less power directly, and requires less power to cool as well. As of 2007, 93%-efficient power supplies are available [1]. Resonant-transition or quasi-resonant switching regulators could achieve over 90% energy efficiency, and also reduce radio frequency interference.
It's important to match the capacity of a power supply to the power needs of the computer. The energy efficiency of power supplies drops significantly at low loads. Efficiency generally peaks at about 50-75% load. The curve varies from model to model (for examples of what this looks like see the test reports of efficient models found on the 80 PLUS website [2]). One rule of thumb is that a power supply which is over twice the required size will be much less efficient, and waste electricity.

Small facts to consider

★ Common certification marks for safety are the UL mark, GS mark, TÜV, NEMKO, SEMKO, DEMKO, FIMKO, CCC, CSA, GOST R and BSMI. Common certificate marks for EMI/RFI are the CE mark, FCC and C-tick. The CE mark is required for power supplies sold in Europe.

★ Life span may be measured in MTBF and should be at least 100,000 hours. Higher MTBF ratings are preferable for longer device life and reliability. Quality construction consisting of industrial grade electrical components and/or A higher speed fan can help to contribute to a higher MTBF rating by keeping critical components cool thus preventing the unit from overheating. Overheating is a major cause of PSU failure.

★ There usually is a sticker on the PSU with a list of certifications, the specification, and a warning not to open the enclosure.

★ Some power supplies have a passive PFC, some have active PFC, while others may be just regular power supplies without any form of PFC circuit. Active PFC is the most effective. Active PFC can have 99% PFC.

★ In computer power supplies that have more than one 12V power rail, it is preferable for stability reasons to spread the power load over the 12V rails evenly to help avoid overloading one of the rails on the power supply.

★
★ Multiple 12V power supply rails are separately current limited as a safety feature; they are not generated separately. Despite widespread belief to the contrary, this separation has no effect on mutual interference between supply rails.

★
★ The ATX12V 2.x and EPS12V power supply standards defer to the IEC 60950 standard, which requires that no more than 240 VA be present between any two accessible points. Thus, each wire must be current-limited to no more than 20 A; typical supplies guarantee 18 A without triggering the current limit. Power supplies capable of delivering more than 18A at 12V connect wires in groups to two or more current sensors which will shut down the supply if excess current flows. Unlike a fuse or circuit breaker, these limits reset as soon as the overload is removed.

★
★ Because of the above standards, almost all high-power supplies claim to implement separate rails, however this claim is often false; many omit the necessary current-limit circuitry (one example), both for cost reasons and because it is an irritation to customers.[3] (The lack is sometimes advertised as a feature under names like "rail fusion" or "current sharing".)

★ When the computer is powered down but the power supply is still on, it can be started remotely via Wake-on-LAN and Wake-on-Ring or locally via Keyboard Power ON (KBPO) if the motherboard supports it.

★ Most computer power supplies are of type switched-mode power supply (SMPS).

★ Most computer power supplies have short circuit protection, overpower (overload) protection, overvoltage protection, undervoltage protection, overcurrent protection, and over temperature protection.

★ Some power supplies come with sleeved cables, which is aesthetically nicer, makes wiring easier and cleaner and have less effect on airflow.

★ There is a popular misconception that a greater power capacity (watt output capacity) is always better. If all else is equal, this is true, but since supplies are self-certified, a manufacturer's claims may be double or more what is actually provided. Although a too-large power supply will have an extra margin of safety, if it is over twice the needed size, it will be less efficient, and waste electricity. Also, computer power supplies generally do not function properly if they are too lightly loaded. Under no-load conditions they may shut down or malfunction.

★ Power supplies do not always live up to what they are marketed. Noise can be measured from different distances and at different room temperatures.

Wiring diagrams

AT power connector (Used on older AT style mainboards)

Color	Pin	Signal
	P8.1	Power Good
	P8.2	+5 V
	P8.3	+12 V
	P8.4	-12 V
	P8.5	Ground
	P8.6	Ground
	P9.1	Ground
	P9.2	Ground
	P9.3	-5 V
	P9.4	+5 V
	P9.5	+5 V
	P9.6	+5 V

24-pin ATX power supply connector
(20-pin omits the last 4: 11, 12, 23 and 24)

Color	Signal	Pin	Pin	Signal	Color
	+3.3 V	1	13	+3.3 V sense
	+3.3 V	2	14	-12 V
	Ground	3	15	Ground
	+5 V	4	16	Power on
	Ground	5	17	Ground
	+5 V	6	18	Ground
	Ground	7	19	Ground
	Power good	8	20	-5 V
	+5 V standby	9	21	+5 V
	+12 V	10	22	+5 V
	+12 V	11	23	+5 V
	+3.3 V	12	24	Ground

False Advertising

The DIY boom has led to power supply manufacturers marketing their products directly to end users, often with grossly inflated specs. Some of the main tricks employed are...

★ advertising the peak wattage, rather than the continuous wattage

★ determining the wattage at unrealistically low temperatures (below 40C)

★ advertising total wattage as a measure of capacity, when modern systems are almost totally reliant on the number of amps on the 12 volt line(s)
So if...

★ PSU A - has a peak rating of 500 watts at 25C, with 25 amps on the 12 volt line

★ PSU B - has a continuous rating of 500 watts at 40C, with 33 amps on the 12 volt line
..and those ratings are accurate, then PSU B would have to be considered a vastly superior unit, while PSU A may only be capable of delivering a fraction of its rated wattage under real world conditions.

Modular power supply

A 'modular power supply' is a relatively new approach to cabling, allowing users to omit unused cables. Whereas a conventional design has a continuous cable with two connection points (pcb-to-device), a modular design has two cables, adding another connection point (pcb-to-modular plug-to-device). The main benefits of a modular design, reduced clutter and improved airflow, come at the expense of added resistance, which can reduce power delivery and increase failure rates.

Troubleshooting

A power supply is tasked with providing electricity to every component in a computer, so a faulty or under performing unit will often cause a wide range of symptoms, including, but not limited to:

★ Failure to power on.

★ General instability.

★ Rebooting, either randomly or when the computer is stressed.

★ Hardware failure, due to sudden power spikes/dips or long term 'electronic noise'.

Capacitors

Bad or leaky capacitors. See capacitor plague.
Solid capacitors are good.

Noisy fan

Most desktop computer power supplies are equipped with an exhaust fan, which helps to keep internal components cool and operate more efficiently. Abnormal fan noise is generally caused by a lack of internal lubrication or failing motor. While it's relatively easy and inexpensive to lubricate/replace a fan, opening a power supply can be very dangerous and usually voids the warranty, so it's best left to a professional.

See also

★ Green computing

★ Power management

★ Power supply

★ List of manufacturers

External links

★ "80 PLUS" Certified Energy Efficient Power Supplies Program

★ Website with Information & Research on Active Mode Power Supply Efficiency

★ How to Buy an Energy-Efficient

★ Computer Power Supply - Schematics, Reviews, Repair Guides

★ PC Repair and Maintenance: In-depth Look at Power Supply

★ X-bit labs - ATX Power Supply Units Roundup. Part V

★ ATX12V Power Supply Design Guide v2.2

★ Power Supply Design Guide for Desktop Platform Form Factors Revision 1.1

★ How to Discover Your Power Supply Real Manufacturer

★ Dell non-standard Power Supplies

Computer Power Supply Calculators

★ eXtreme Power Supply Calculator (frequently updated)

★ Schrock Innovations' Power Supply Requirement Calculator (outdated)

★ Computer Power Supply Calculator (outdated)

★ JOURNEYSYSTEMS' online power supply calculator (outdated)