HUMBUCKER

A conventional 'humbucker' (or Humbucking pickup) is a type of electric guitar pickup that uses two coils, both generating string signal. Humbuckers have high output since both coils are in series and because the magnetic circuit is low loss. Since the two coils are of reversed polarity and reverse-wound and connected in series, noise and interference is significantly reduced via common-mode rejection. They get their name because they cancel out a large proportion of the mains induced hum (they "buck the hum") normally experienced with single coil pickups.

Contents

History

How humbuckers work

Sound

Alternative humbucker designs

Stacked humbuckers

Coil splits

Notable humbucker designs

Other noise-reducing pickup designs

See also

References

History

This first "humbucker" or humbucking pickup was the so-called PAF (literally "Patent Applied For") invented by Seth Lover, a Gibson employee, in the 1950s. Because of this, and because of its use on the Gibson Les Paul guitar, the humbucker is strongly associated with Gibson, although humbuckers have been used in many different guitar designs by many different manufacturers. Humbuckers are also known as ''dual-coil'', ''double-coil'', or ''hum-canceling'' pickups. Rickenbacker offered dual coil pickups arranged in a humbucking pattern beginning in late 1953 but dropped the design in 1954 due to the perceived distorted sound. The Gibson Les Paul was the first guitar to use humbuckers in substantial production, but since then, even some models of Fender Stratocasters and Telecasters, traditionally fitted with single-coil pickups, are factory-equipped with humbuckers. Stratocasters fitted with one humbucker in the bridge position, resulting in a pickup configuration noted as H-S-S (starting at bridge pickup: H for humbucker, S for single coil) is referred to as "Fat Strats", because of the "fatter", "rounder" tone offered by the humbucker pickup.

How humbuckers work

In any magnetic pickup, a vibrating soft-magnetic guitar string induces an alternating voltage in its coil(s). However, magnetic coils also make excellent antennas and are therefore sensitive to electromagnetic interference caused by mains wiring (mains hum) and electrical appliances like transformers, motors and computer screens. Guitar pickups pick up this noise, which can be quite audible, sounding like a constant hum or buzz.
A humbucker has two coils with opposing windings and polarities. The string motion induces current in both coils in the same direction. Electromagnetic interference, on the other hand, induces current in opposing directions in each coil because of the reversed winding and polarity. When the signals from both pickups are summed together, the noise is cancelled due to destructive interference, while the actual signal is increased due to constructive interference, thus dramatically improving the signal-to-noise ratio. This technique is called common-mode rejection by electrical engineers, and is also used in balanced lines in audio recording.

Sound

Using two coils also changes the tone of the pickup. The humbucker pickup produces a "warm" and "fat" tone that has been popularly associated with Les Pauls and SGs, in contrast to the "bright" or "clear" tone of the single coil pickups that are typically used on Fender guitars such as the Stratocaster and Telecaster.
It is a common misconception that because the coils are at slightly different positions along the string some of the higher-frequency harmonics are diminished or cancelled out, thus producing this warmer sound. The main reason humbuckers sound different is because two coils resonate at different frequencies causing a broad resonant peak in frequency response, a characteristic of the original Gibson humbuckers, and because any two pickups wired in series will attenuate some of the higher frequencies due to the summed impedance.
Usually, those who prefer the brighter sound of single-coil pickups had to simply live with the extra hum and buzz in order to get the tone they prefer, although technologies designed to preserve the tones exist.

Alternative humbucker designs

Stacked humbuckers

Solid body guitars such as Fender Stratocasters usually feature cavities only for single-coil pickups. Installing full-sized humbuckers requires additional routing of the woodwork and cutting of the pickguard (if the instrument has a pickguard). If the process is not carefully done, the instrument's body and pickguard may be damaged and possibly affecting the tone produced by the body. This is unacceptable, especially for expensive vintage guitars where it is vital to preserve cosmetic appearance. As a result, many pickup manufacturers now produce humbucking pickups compacted into the size of a single coil, accomplished by vertically "stacking" the coils instead of placing them side-by-side as in a regular humbucker. Stacked humbuckers sound similar to, but not exactly like, regular humbuckers, and some players prefer this tone.
Although the Fender Stratocaster-style single coil is by far the most frequently found pickup in a single coil size, humbuckers are available for most single-coil guitars. Fender produces several variations in their Telecaster, Jaguar, Jazzmaster, and Mustang guitars.

Coil splits

Some guitars which have humbucker pickups feature coil splits, which allow the humbucker pickups to act as "pseudo-single" coils. The electrical circuit of the pickup is reduced to that of a true single coil while the magnetic circuit retains its original closed loop configuration. Usually, this feature is activated using a switch on the tone potentiometer. Coil split turns on when potentiometer is pulled out and reverts back off when it is pushed in. The resultant single coil sound is not the same as a Fender single coil sound because the poles of the coil are made of steel and not of alnico, and the coil turns are significantly less than a Fender pickup (5,000 as distinct to 8,000 - this can vary depending on the type and brand of the humbucker).
:''Note: this is often wrongly referred to as "coil taps". Coil taps are more commonly found on single coil pickups, and involve an extra hook-up wire being included during the manufacture of the pickup so the guitarist can choose to have all the windings of the pickup included in the circuit, for a fatter, higher output sound; or some of the windings in use and some "tapped off" for a brighter, lower output, cleaner sound.''

Notable humbucker designs

★ Gibson "PAF" - Seth Lover's original humbucker design

★ Fender Wide Range - Fender's first humbucker design, also by Seth Lover

★ Gibson mini-humbucker - a smaller humbucker design used on the Gibson Firebird

Other noise-reducing pickup designs

While the original humbucker remains the most common noise-reducing pickup design,
inventors have tried many other approaches to reducing noise in guitar pickups.
Many Stratocaster style guitars are equipped with a reverse-wound, reverse-polarity pickup in the middle position and a 5-way selector switch that allows the middle pickup to be used in parallel with either the bridge or neck pickup. This arrangement is similar to a humbucker's, and noise is effectively cancelled. This does affect tone (commonly referred to as "quack"), but some players find this sound useful.
Since its introduction in 1960, the Fender Jazz Bass has used two single-coil pickups, one near the bridge and another about halfway between the bridge and neck. These pickups are wound to be opposite in magnetic polarity and electrical phase. Thus, when used together hum is reduced significantly.
In 1957, Fender introduced a split pickup to its Precision Bass, which was wired in humbucking fashion, with one coil serving the E and A strings, the other the D and G strings. Both coils pick up the same noise, but since each string is only served by one coil, a single-coil sound is provided.
In 1985, Lace Music Products introduced the Lace Sensor pickups, which utilize a proprietary hum-screening technique to eliminate noise while preserving single-coil tone.
In 1996, Kinman Guitar Electrix introduced pickups based on a differential coil technology, essentially a stacked humbucker where the lower pickup coil functions solely as a noise sensing coil, while only the upper pickup coil is able to sense the string vibrations.

See also

★ Single coil

References

★

★ Humbucking Pickup Specifications [1] compiled by Axiomatic Music