Plasma Ignition - Water Sparkplug Circuit by Peter Lindemann




Title:
Plasma Ignition - Water Sparkplug Circuit by Peter Lindemann

Description:
This is Peter's duplication of the circuit that Aaron made that isolates the capacitor/charger connection to the capacitor primary connection. For details, visit the Water Sparkplug thread at www.energeticforum.com

Author:
energeticforum

Tags:
plasma, ignition, spark, plug, stan, meyer, peter, lindemann, gotoluc, hho, water, cold, electricity, potential, radiant, energy, fuel,

Related Videos:

Water Sparkplug | Plasma Ignition | With current restriction
Silent plasma ignition effect from choke. The coil of wire creates a magnetic field that restricts current.
Water Sparkplug | Plasma Ignition| Booster Caps
Booster caps in parallel to plug as low voltage source. Golf ball size bursts that could not be captured by film
Simple PWM and new hydrogen cell test
created a pwm for hho testing, schematics searched from google
Peter Lindemann Rotary Attraction Motor 2a
In depth demo showing rotary attraction motor running without a load, with load, etc.. You will see that the more you load it the less it takse and there is no back EFM.
#4 HHO Dual anode Plasma spark plug prototype
HHO Dual anode Plasma spark plug prototype. It was a Champion CJ8 plug out of a 16hp electric start lawn mower engine. We busted out the inside to make way for the new anode test tubes. The electrical tape and rubber hose will not hold up in the cylinder but it will work fine for a few bench tests (which we'll post after we get some videos). Thank you 'gotoluc' and all the other youtubers that have been working on the new spark plug designs. Click the link below for more videos here or check ...
#1 InfiniStorm Dual Ignition Coil Circuit - Part 1
DANGER HIGH VOLTAGE!!! Do not attempt to build this if you don't know what you are doing! This is an ignition coil circuit I am re-creating from memory. This is stage one. I don't have all the parts hooked up yet. I am still waiting on some parts to come in as well. This is part of the infinistorm ignition system that I am designing. The purpose of this circuit is to run an engine directly on water without the need for HHO cells or any other fuel source. I am not including a driver schematic ...
water plasma engine
My first video of the construction of the water plasma engine, water fuel generator and plasma burner tube.
Water Sparkplug Circuit Verification
This is the first test I did with nails instead of a resistor-less spark plug. Charging cap and dumping to coil. With and w/out diode.
Engine Running On Plasma Ignition-2 (Gasoline)
In this video I used no relay, no reed switch, and no car coil ignition. I used what Tero suggested in a yahoo forum. 220 Volt from rectifier connected directly to 47 uf 250 volt and spark plug. Ignition switching by original engine's ignition spark. The spark result is the same as my previous video because the same capasitor used. Engine with 100% gasoline runs with more power even though in fully closed carb throttle valve.
Spark Plasma Sintering of Ceramic Nanocomposites
Sinterización de materiales cerámicos nanoestructurados mediante la técnica de Spark Plasma Sintering (SPS).
TripAtlas.com on Facebook